Dryer Plinth Kit (115mm & Under Counter)
Part Numbers: 94832 & 94852
KIT COMPONENTS
S
S
S
S
S
S
Wrapper plinth 115mm / Under counter
Back plinth 115mm / Under counter
Screw (15)
Fit plinth between
wrapper & base panel
Beam (2)
Foot (4)
Instruction leaflet
Back Panel
ASSEMBLY METHOD
1. Lay dryer on its back.
2. Loosen all 16 screws around perimeter of dryer base. Do not remove
wheels or feet.
3. Fit plinth by inserting the top flange of plinth (the flange with the 16
notches) between the base panel and dryer cabinet bottom flange.
Fit front flange first springing the sides outward to assist assembly.
Plinth
4. Adjust plinth to fit flush with the cabinet then tighten screws.
5. Fit front and rear beams using the screws provided.
Screws
6. Remove screws from lower rear panel and re-use to fit back plinth
panel. Also use screws supplied to secure sides and bottom edge of
panel.
7. Screw feet into beams.
Beams
Foot
8. Stand dryer upright and adjust feet to desired height.
Introduction Date: September 2004
Instruction Sheet Pt No. 460633 Issue E
|